Services
Everything between the outdoor unit
and a perfect indoor afternoon
Four disciplines, one standard: measured results, flat-rate pricing, and a mechanical room left cleaner than we found it.
Cooling
AC repair
A weak or warm AC is a symptom. Low airflow, a failing capacitor, a slow refrigerant leak — the causes look identical from the couch. Our diagnostics start with measurements, so the repair fixes the fault instead of masking it.
- Full-system diagnostic: pressures, superheat/subcooling, static pressure, amp draws
- Written flat-rate quote approved by you before a single panel comes off
- Common-failure parts stocked on the truck — most repairs finish in one visit
- Post-repair verification: we re-measure and show you the delta-T recovery
If the honest answer is “this system is near end-of-life,” we’ll show you the repair-versus-replace math side by side and let you decide. No pressure, no scare quotes.
Heating
Heating service & repair
Fairview winters don’t negotiate. We keep furnaces, heat pumps, and boilers running safely and efficiently — and when something fails at 11pm in January, the emergency line reaches a human, not a voicemail tree.
- Combustion analysis with printed readings — not a mirror-and-flashlight glance
- Heat-exchanger and carbon-monoxide safety inspection on every service
- Heat-pump defrost and balance-point tuning for shoulder-season efficiency
- Honest end-of-life guidance with repair-versus-replace numbers in writing
Cold spots in specific rooms are usually a distribution problem, not an equipment problem. We diagnose ductwork and zoning too, so you don’t buy a bigger furnace to fix a crushed duct.
Installation
Installation & replacement
An oversized system short-cycles; an undersized one never catches up. Getting it right starts with math — a room-by-room load calculation — and ends with commissioning numbers you can hold us to.
- Manual-J load calculation and duct evaluation before we quote equipment
- Good/better/best options quoted flat-rate, with operating-cost estimates
- Heat pumps, high-efficiency furnaces, central AC, and ductless mini-splits
- Commissioning to manufacturer spec, documented and left with you
How an install runs
- Inspect
Load calculation, duct check, and a conversation about how you actually use the space.
- Quote
Three flat-rate options with efficiency and operating-cost math. You pick; the price locks.
- Install
Drop cloths down, old unit out, new system in — typically one to two days, commissioned to spec.
- Support
Walkthrough, thermostat setup, registration, and a 30-day follow-up check on us.
Maintenance
Maintenance plans
Nearly every mid-July breakdown we see left a calling card in April: a weak capacitor, a clogged condensate line, a coil running ten degrees off. Planned maintenance catches those for the price of a pizza night.
| What’s included | Baseline $14/mo |
Steady 72 $26/mo |
Meridian+ $42/mo |
|---|---|---|---|
| Precision tune-ups per year | 1 | 2 | 2 |
| Priority scheduling | — | ✓ | ✓ |
| Repair discount | 10% | 15% | 20% |
| No overtime rates | — | ✓ | ✓ |
| Condensate & safety inspection | — | ✓ | ✓ |
| Same-day emergency dispatch | — | — | ✓ |
| Annual duct static-pressure report | — | — | ✓ |
| Filter reminders & seasonal checklist | ✓ | ✓ | ✓ |
Not sure which service you need?
Describe the symptom; we’ll tell you what it usually means and what it usually costs.